Whirlpool RJE-320-B manual Cleaning and caring for your range

Pull knob and trim ring straight out. Remember how the spring goes.

To remove surface unit, lift and pull straight out.

Hold surface unit level when replacing.

Cleaning and caring for your range

Your range is designed to be easy to clean. You will usually wipe off spills and spatters when they happen, but you will sometimes want to clean under and behind the control knobs and surface units. This section will tell you how to remove those, and what to use when cleaning.

Removing and replacing surface unit control knobs:

1.Be sure the control knobs are set to “OFF.”

2.Pull the black knobs straight off.

3.If the control has a chrome trim rins. oull it straiaht off.

4.Wash the knobs (and trim rings) in&m, sudsywater.

5.Replace the trim rings first. If the control spring was removed, put it back exactly as shown on the left.. .small end first.

6.Hold the black knob so it points to “OFF.” Push it straight back on.

Removing and Replacing Oven Control Knobs:

1.Be sure the knobs are set to “OFF.”

2.Pull each knob straight off.

3.Wash the knobs in warm, sudsy water.

4.The knobs are not interchangeable. Make sure you put the adjust- able Oven Temperature Control Knob on the right place, and the nonadjustable Oven Selector Knob on the other.

Removincl surface units and reflector bowls:

Firs< be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.

Lift each surface unit about an inch (2.5 cm) at the edge away from the plug-in (receptacle). Pull the unit straight away from the plug-in. Do not wash surface units: they will burn themselves clean during normal use.

Lift out the reflector bowls.

Replacing reflector bowls and surface units:

1.Be sure the surface unit controls are on “OFF.”

2.Put the reflector bowls back into their places. Make sure you can see the plug-ins (receptacles) for the surface units through the square hole in the side of each bowl.

3.Hold the surface unit level with the prongs (terminals) pointing at the plug-in.

4.With the prongs started in the plug-in, start pushing in on the surface unit. At the same time, lift a little on the side of the surface unit that’s by the plug-in.

5.Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit should fit into the reflector bowl and be level.

9