Whirlpool SF376PEW manual Usingand replacingthe light bulbs

Models: SF376PEW

1 32
Download 32 pages 20.43 Kb
Page 27
Image 27
Usingand replacingthe light bulbs

Usingand replacingthe light bulbs

The cooktop light

The fluorescent light is on the bottom of the control panel. The Top Light Switch is located on the left side of the front control panel.

Electrical Shock and Burn Hazard

Make sure power to the range has been disconnected at the main power supply and that all surface burners are OFF and cool. Failure to do so could result in electrical shock or burns.

To replace the cooktop light:

1.Turn off all control knobs and unplug appliance or disconnect at the main power supply.

2.Pull Set Knob straight off.

3.Remove the four screws in the center of the oven vent grille. DO not remove two top screws.

4.With both hands, carefully remove oven vent grille and control panel glass.

5.Roll bottom of fluorescent tube towards you until both ends can be pulled out of the receptacles. Replace with a 20-watt cool-white fluorescent tube.

6.Insert control panel glass into top slot of the oven vent grille. Carefully replace glass and grille.

NOTE: The control panel glass must fit under the top lip of the upper control panel frame.

7.Replace the four screws in the oven vent grille.

6. Push Set Knob straight on.

9. Plug in appliance or reconnect at the

main power supply.

27

Page 27
Image 27
Whirlpool SF376PEW manual Usingand replacingthe light bulbs