6. After cleaning the gas tube opening and
ports, replace the burner cap and burnerLocating pegs grate. To replace burner cap, make
sure cap is properly aligned and leveled. Fit locating pegs into the recess in the underside of the cap. The cap must be correctly seated on the burner body for proper operation of the burner.
7.Turn on the burner to determine if it will light. If the burner does not light after cleaning, contact an authorized Whirlpool service technician. Do not service the sealed burner yourself.
Cleaning chart
Use the following table to help you clean your range.
PART | WHAT TO USE |
Control knobs | Sponge and warm, |
| soapy water |
Control panels Sponge and warm, soapy water
OR
HOW TO CLEAN
l Turn knobs to OFF and pull straight away from control panel.
l Wash, rinse, and dry thoroughly. Do not soak.
l Do not use steel wool or abrasive cleansers. They may damage the finish.
l Replace knobs. Make sure all knobs point to OFF.
l Wash, wipe with clean water, and dry thoroughly.
l Do not use steel wool or abrasive cleansers. They may damage the finish.
Paper towel and spray glass cleaner
Exterior surfaces Sponge and warm, (other than control soapy water panels)
l Do not spray cleaner directly on panel. Apply cleaner to paper towel.
l Wash, wipe with clean water, and dry thoroughly.
l Use nonabrasive, plastic scrubbing pad on heavily soiled areas.
l Do not use abrasive or harsh cleansers. They may damage the finish.
NOTE: Do not allow foods containing acids (such as vinegar, tomato, or lemon juice) to remain on surface. Acids may remove the glossy finish. Also wipe up milk or egg spills when cooktop is cool.
