To Convert Oven Bake Burner
1.Remove oven racks.
2.Use a ½" combination wrench to turn the orifice hood clockwise (about 2 to 2½ turns) so it is snug onto the pin.
IMPORTANT: Do not overtighten.
NOTE: Turning the orifice hood clockwise will decrease flame size; turning it counterclockwise will increase flame size.
The oven bake burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Bake Burner Flame” in the “Electronic Ignition System” section.
A
B
A
A
A. Orifice hood
B. Pin
To Convert Oven Broil Burner
1.Use a ½" combination wrench to turn the orifice hood clockwise (about 2 to 2½ turns) so it is snug onto the pin.
IMPORTANT: Do not overtighten.
NOTE: Turning the orifice hood clockwise will decrease flame size; turning it counterclockwise will increase flame size.
The oven broil burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Broil Burner Flame” in the “Electronic Ignition System” section.
A
B
A. Locking screw
B. Orifice hood
2.Reinstall the warming or storage drawer. See the “Replace Oven Racks and Warming or Storage Drawer” section for instructions.
3.Complete installation. See “Make Gas Connection” and “Electronic Ignition System” sections.
Checking for proper cooktop burner flames and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" (0.6 cm) to ½" (1.3 cm) long.
The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
To Convert Gas Pressure Regulator
1.Turn manual shutoff valve to the “closed” position.
2.Unplug range or disconnect power.
B
A
C
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line
3.Remove warming drawer or storage drawer. See the “Remove Warming or Storage Drawer” section for instructions. Locate gas pressure regulator at rear of storage or warming drawer compartment.
NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
15