Bradley Smoker MG-2/BIR3 installation instructions Installation Instructions

	Express® Lavatory System - MG Series with Battery Infrared Control
Installation Instructions	MG-2/BIR3

Installation Instructions

Step 1: Rough in supplies and optional hot water heater

NOTE: See Figure 1 (below), 1a, 1b (for TAS on page 6) and Figure 2 (on page 7) when roughing in the MG-2/BIR3 Express®.

IMPORTANT: Flush the supply lines before making connections. Debris in supply lines will cause the valves to malfunction.

IMPORTANT: Dimensions shown in Figure 1 are for Standard Height Mounted MG-2/BIR3 Express®.

1.Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.

2.Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.

Standard Height Mounting

CENTERLINE OF FIXTURE

		25-1/2" (648)		25-1/2" (648)
		APPROX. DIMENSION		APPROX. DIMENSION	1-1/2" NPT DRAIN
		14"		14"
					STUB OUT 2"
		(356)		(356)
		4"		4" (102)
		(102)
		4"
	A	(102)			A
		B	B	B
		H	C
					*28-1/4"
					(718)
*31-1/2"		B	B	B
(800)					*25-3/4"
	*26"				(654)
	(660)				*24-1/2"
					(654)
					*19-1/2"
					(495)
				FLOOR

1/2" NPT HOT AND COLD SUPPLIES OR TEMPERED SUPPLY – STUB OUT 2"

3/8" WALL ANCHORS (8) PLACES MIN. PULL-OUT STRENGTH 1000 LBS. PER ANCHOR

*Juvenile Height Mounting:

Figure 1 Subtract 4" from vertical dimensions for compliance with ADA guidelines for children's use.

Bradley Corporation • 215-1510 Rev. D; ECN 07-815 8/23/07 5