The Oven Vent
Hot air and moisture escape from the oven through a vent located to the rear of the cooktop. Do not block vent. Poor baking will result.
Lighting Standing Pilots
To light Cookto~ . Pilots:
1.Remove the surface burner grates from the cooktop. Lift the cooktop and rest on support rod.
2.Make sure all controls are OFF.
To light Oven Burner Pilot:
1.Make sure the oven control is OFF.
2.Remove the broiler drawer. Slide drawer out to stops, lift both sides, then slide the rest of the way out.
3.To light, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be % to J/e in
4.If the pilot flame needs adjust- ment, turn the pilot adjustment screw on the manifold pipe.
5.Lower the cooktop and replace the surface burner grates before using the surface burners.
II
3.Hold a lit match over the oven burner pilot located at the rear of the burner.
4.After the oven burner pilot is burn- ing steady, check burner lighting by turning the Oven Control to a temperature obove140”F (60°C). The burner will take
5.Replace the broiler drawer.
9
