Whirlpool T-K1S installation manual Computer Board, Error Codes, TK-RE01

Error Codes

All Takagi units are self diagnostic for errors. If there is a problem with the installation or the unit, it will give a signal, through a flashing light on the circuit plate, to communicate the source of the problem. If the unit has a TK-RE01 remote control installed, this will give also give a numerical error code. Consult the following chart for the meaning of an error code:

TK-RE01

Computer Board	TK-RE01	Check Point
Blinking One Time	03	Wrong Gas
	70	Computer Board
	71	Solenoid Gas Valve
Blinking Two Times	31	Output Thermistor
	32	Input Thermistor
	11	Hi-limit, Igniter
Blinking Three Times	12	Flame Sensor, Hi-limit
	55	Main Gas Valve
	51	Proportional Gas Valve
	72	Abnormal Burning
Blinking Four Times	61	Fan
	21	Pressure switch
	74	Remote Controller

For technical support contact Takagi toll free at (888) 882-5244, or check

our website at www.takagi-usa.com.

19