Whirlpool T-K1S Optional Items, TKRE01emperature Remote Controller, TK-TV03Vent Damper

Optional Items

1. TKRE01emperature Remote Controller								3. TK-TV03 Vent Damper
			The			TKRE01		The TK-TV03 Vent
			temperature			Remote		Damper prevents the
			Controller		has		two	backflow	of	air
			functions, it allows				the	through the	exhaust
			output		temperature			vent. This	is	CSA
			from the T-K1S to be					approved part of the
			adjusted		within		the	unit. This helps prevent harmful exhaust gases
			range of 95 °F to 167					from entering the home, as well as helping to
°F, and it also works as a diagnostic tool that will								prevent the units from freezing in areas where
give a concise error code whenever there is a								cold air can be blown into the exhaust system.
problem with the unit. The temperature options								Install vent damper according to manufacturer’s
are 95°F, 100°F, 102°F, 104°F, 106°F, 108°F,								installation instruction, and any applicable codes.
109°F,	111°F,	113°F,	115°F,	117°F,		122°F,
131°F, 140°F, 158°F, and 167°F. See the trouble
shooting section for information on possible error
codes.

3. TK-TV01 Vent Terminator	4. TK-TV03 Vent Cap
This terminator can be used	The TK-TV03 Vent Cap is for
where a T-K1S is going to be	outdoor installation with the
vented out through a wall. This	T-K1S water heater. The cap
is a CSA approved part of the	is installed on the top of the
unit. Connect a Category III	unit, instead of connecting an
Stainless vent pipe from the	exhaust vent. The cap will
top of the unit to the backside of this terminator to	prevent any debris that might
exhaust flue gases through the wall without a	be in the environment from entering the unit and
thimble. Install vent terminator in accordance with	causing damage or a fire hazard, as well as
manufacturer’s installation instructions and any	preventing rain or other weather from entering the
applicable local codes.	unit.

5. TK-BK01 Wall Mounting Brackets

The TK-BK01 Wall Mounting Brackets allow the T-K1S to be installed hanging from a wall. It is not necessary to earthquake strap these heaters if these brackets are used. If the unit is not going to be mounted on a wall, the “L” brackets that are included with every unit will be sufficient as earthquake protection. Install unit and brackets according to manufacturer’s installation instructions and any applicable codes.

20