|
| 2. Move the door strike |
Door Reversal (optional) | ||
The following instructions are for models with a
IMPORTANT: For models with a square shaped door, an additional kit is needed. Please contact your retailer, or see the For Assistance or Service page in your Use and Care Guide.
Tools needed:
|
|
|
|
|
|
|
|
|
|
Min. 8” long Torx® T25 | #2 Phillips screwdriver | |||
screwdriver |
| |||
1. Remove door from dryer
IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding.
Using a Torx® T25 screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other
Using a Torx®† T25 screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown.
3. Remove inner door from outer door
Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside.
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
19
