INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Parts needed: (Not supplied with dryer) ■■Vent clamps
■■Vent elbows and ductwork
Additional parts may be required, depending in your installation. Check local codes. Check existing electrical supply and venting. Read “Electrical Requirements” and “Venting Requirements” before purchasing parts.
#2 Phillips screwdriver | If using a power supply cord: | |
|
| |
|
| Use a UL listed power supply cord kit marked for use with |
|
| clothes dryers. The kit should contain: |
|
| ■■A UL listed |
|
| minimum. The cord should be type SRD or SRDT and be |
|
| at least 4 ft. (1.22 m) long. The wires that connect to |
|
| the dryer must end in ring terminals or spade terminals |
|
| with upturned ends. |
Wire stripper (direct wire | Tin snips (new vent | ■■A UL listed strain relief. |
installations) | installations) |
|
1/4" and 5/16" nut driver (recommended)
Adjustable wrench that opens to 1" (25mm) or
Parts supplied:
Parts package is located in dryer drum. Check that all parts are included.
NOTE: Do not use leveling legs supplied if installing with a pedestal or a stack kit.
Utility knife
Level
Tape measure
Pliers
Leveling legs (4)
Short inlet hose
Rubber washer
“Y” connector
Long inlet hose
Caulking gun and compound (for installing new exhaust vent)
Min. 8" long Torx® T25 screwdriver
(for door reversal only)
Optional Equipment: (Not supplied with dryer) Refer to your Use and Care Guide for information about accessories available for your dryer.
® TORX is a registered trademark of Saturn Fasteners, Inc.
3
