Burner Input Requirements
Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).
For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level.
Gas Supply Pressure Testing
Line pressure testing above 1/2 psi gauge (14" WCP)
The range and its individual manual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psi (3.5 kPa).
Line pressure testing at 1/2 psi gauge (14" WCP) or lower
The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of that system at test pressures equal to or less than
1/2 psi (3.5 kPa).
INSTALLATION INSTRUCTIONS
Unpack Range
1.Do not use oven door handle to lift or move the range.
2.Remove shipping materials, tape and film from range. Keep cardboard bottom under range. Remove oven racks and parts package from inside oven.
3.Take 4 cardboard corners from the carton. Stack one cardboard corner on top of another. Repeat with the other 2 corners. Place them lengthwise on the floor behind the range to support the range when it is laid on its back. Using 2 or more people, firmly grasp the range and gently lay it on its back on the cardboard corners.
4.Pull cardboard bottom firmly to remove.
5.Use an adjustable wrench to loosen the leveling legs. Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A maximum of 3/16" (5 mm) is needed to engage the
NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs.
6.Place cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto cardboard or hardboard.
A
A. Cardboard shipping base
Install Anti-Tip Bracket
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
Contact a qualified floor covering installer for the best procedure for drilling mounting holes through your type floor covering.
Before moving range, slide range onto shipping base, cardboard or hardboard.
1.Remove template from the
2.Place template on the floor in the cabinet opening so that the left edge is against the cabinet and the top edge is against the rear wall, molding or cabinet.
3.Tape template in place.
4.If the countertop is not flush with the cabinet opening edge, align the template with the overhang.
If the cabinet opening is wider than specified in the “Location Requirements” section, adjust the template so the range will be centered in the cabinet opening.
7
