2. Washer transport bolts
Locate the transport bolts on rear of washer. Transport bolts must remain in washer while pedestal is installed. When laying the washer on its back, hold the base down on the floor. Do not remove the plastic film, corner posts, or top cap.
INSTALLING THE PEDESTAL
Follow these instructions to install the pedestal on a washer or dryer.
1. Locate spacer pads
Make sure that all four spacer pads are in place on the top of the pedestal. Spacer pads reduce vibration between the pedestal and the washer/dryer.
NOTE: If your washer/dryer has feet installed, remove them.
2. Prepare the washer/dryer
Washer Bottom | Dryer Bottom |
Partially install two of the #12 x 5/8"
3. Attach the pedestal
Move the pedestal against the washer/dryer bottom. Slide the pedestal’s keyhole slots over the lower two partially installed screws.
4. Secure the pedestal
Position the pedestal toward the front of the washer/dryer and install the two remaining
4
