10. Adjust pedestal feet

Locate the 1/4" hex-head screws on the top of each pedestal foot. Reach inside the pedestal and use a 1/4" hex-head ratchet or open-end wrench to adjust the feet up or down as needed to level the washer/dryer.

11. Securely tighten jam nuts

When the washer/dryer is level, use a 9/16" open-end wrench to securely tighten all four jam nuts against the pedestal.

IMPORTANT: The jam nuts must be tightened to avoid vibration.

12. Install pedestal front panel

36" (914 mm) tall models, place wide edge of front panel on bottom

38" (965 mm) tall models, place wide edge of front panel on top

Align the front panel with the pedestal and snap in place.

NOTE: Follow the “Showroom Display Kit Installation Instructions” if you wish to use the two retainer clips included in the parts bag. Discard the retainer clips if not used.

6

Page 6
Image 6
Whirlpool W10178072B Adjust pedestal feet, Securely tighten jam nuts, Install pedestal front panel