To make a 7¹⁄₄" (18.4 cm) circle on the underside of the cabinet top:
1.Mark a centerline on the underside of the top of cabinet.
2.Mark a line 5" (12.7 cm) from the back wall on the underside of the top of cabinet.
3.Draw a circle using a compass or 7¹⁄₄" (18.4 cm) circle template.
4.Use saber or keyhole saw to cut a 7¹⁄₄" (18.4 cm) diameter opening.
7 ¹/₄" (18.4 cm) diam.
For vented installations
1.Insert the baffle plate into the slot behind the grille. The locator bumps should be at the top.
A
B
*5" |
(12.7 cm) |
*From wall, not cabinet frame
Cabinet cutouts
A. Locator bumps
B. Baffle plate
2.Remove either top or rear rectangular vent knockout. If using round vent, remove both top rectangular and semicircular knockouts.
3.Install vent connector:
If using a vertical rectangular vent:
Attach rectangular damper/vent connector to the top of the range hood using 2 screws.
Install Vent System
1.Install vent through the vent opening in upper cabinet or wall. Complete venting system according to the selected venting method. See “Venting Requirements” section.
2.Use caulking to seal exterior wall or roof opening around the cap.
Prepare Range Hood
1.Remove terminal box cover. Depending on your installation, remove either back or top wiring knockout.
A
A. Terminal box cover
2.Remove the rectangular and round vent connectors from hood. Set the connectors and screws aside for use if connecting to a rectangular vent system.
If using a horizontal rectangular vent:
Attach rectangular damper/vent connector to the back of the range hood using 2 screws. Insert damper vent connection through the wall cutout and into the vent.
NOTE: If the wall cap is directly behind the vent connector, the dampers in the connector and wall cap must not interfere with each other. Remove the vent connector damper if they interfere.
A
A. Wall/cutout
9
