Whirlpool W10353374A Attach Cooktop to Countertop, Complete Installation, H C I D

3-Wire Cable from Power Supply to 3-Wire Cable from Cooktop

IMPORTANT: Use the 3-wire cable from power supply where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire:

A	E
B
	F
	G

H

C

I

D

A. 3-wire cable from power	E. Junction box
supply	F. White wire (from power supply)
B. Red wires	G. UL listed wire connector
C. Green or bare ground wire	H. Black wires
(from cooktop)	I. UL listed or CSA approved
D. 3-wire cable from cooktop
	conduit connector

1.Disconnect power

2.Remove junction box cover, if present.

3.Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved conduit connector.

4.Tighten screws on conduit connector if present.

5.Connect the two black wires together using the UL listed wire connectors.

6.Connect the two red wires together using the UL listed wire connectors.

7.Connect the green or bare cooktop cable wires to the white (neutral) wire in the junction box using the UL listed wire connectors.

8.Install junction box cover.

9.Reconnect power.

Attach Cooktop to Countertop

NOTE: This section applies only if you are using clamping brackets.

A	G
B	F
	E
	D

	C
A. Glass cooktop	E. 2½" (6.4 cm) clamping screw
B. Cooktop base	F. Countertop
C. Attachment screw	G. Foam seal
D. Clamping bracket (extends
far enough beyond cooktop
base to allow installation of
clamping screws)

1.Place the 2½" (6.4 cm) clamping screws into the outermost hole in the clamping bracket.

2.Use a screwdriver to tighten the screws against the countertop. Do not overtighten.

Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all your tools.

3.Dispose of/recycle all packaging materials.

4.Use a mild solution of liquid household cleaner and warm water to clean cooktop before use. Dry thoroughly with a soft cloth. For more information, see the “Cooktop Care” section of the Use and Care Guide.

5.Read the “Cooktop Use” section in the cooktop Use and Care Guide.

6.Reconnect power.

NOTE: If the cooktop does not work after turning on the power, check that a circuit breaker has not tripped or a household fuse has not blown. See “Troubleshooting” section in the Use and Care Guide for further information.

If You Need Assistance or Service:

Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your cooktop.

8