Whirlpool W10477533B Verify Anti-Tip Bracket Is Installed and Engaged, Complete Connection

3.Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked.

A

B

D

C

	E	F
		G
	H
A. Pressure regulator	E. Adapter
connection fitting	F. Use pipe-joint compound.
B. Use pipe-joint compound.	G. Manual shutoff valve
C. Adapter	H. ½" or ¾" gas pipe
D. Flexible connector

Complete Connection

1.Locate gas pressure regulator in the back of the range.

A

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

2.Check that the gas pressure regulator shutoff valve is in the “ON” position.

A

B

A.“On” position

B.“Off” position

IMPORTANT: The factory default setting is the “ON” position. If the range does not work, verify that the valve is in the “ON” position.

3.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

A

B

A. Closed valve

B. Open valve

4.Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

5.Remove cooktop burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Place burners, burner caps and grates on the cooktop.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

6.Plug into a grounded 3 prong outlet.

Verify Anti-Tip Bracket Is Installed and

Engaged

1.Place the outside of your foot against the bottom front of the broiler, and grasp the lower right or left side of the control panel as shown.

NOTE: If your countertop is mounted with a backsplash, it may be necessary to grasp the range higher than is shown in the illustration.

2.Slowly attempt to tilt the range forward.

If you encounter immediate resistance, the range foot is engaged in the anti-tip bracket.

3.If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, stop tilting the range and lower it gently back to the floor. The range foot is not engaged in the anti-tip bracket.

9