Whirlpool W10545225B Troubleshooting, Oven Light, Appliance Outlets on some models, To Replace

The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the off position.

To Replace:

1.Unplug range or disconnect power.

Oven Light

2.Turn the glass bulb cover in the back of the oven counterclockwise to remove.

3.Turn bulb counterclockwise to remove from socket.

4.Replace bulb, then bulb cover by turning clockwise.

5.Plug in range or reconnect power.

Appliance Outlets (on some models)

The 120-volt appliance outlet located on the control console may be used to run portable appliances placed on countertops beside the range.

The outlet operates independently and is not affected by range control settings.

NOTE: Do not place portable appliances on the cooktop. Damage to the portable appliance could result if the cooktop is hot.

Appliance Outlet Circuit Breaker:

The circuit breaker for the appliance outlet on your range is located next to the outlet. It is rated for 12 amps.

If the circuit breaker trips, it can be reset by pressing the switch. A delay of several minutes may be required for the circuit breaker to cool before it will reset.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

www.whirlpool.com

In Canada, reference the Customer Service section at www.whirlpool.ca

Operation

PROBLEM	POSSIBLE CAUSES	SOLUTIONS
Nothing will operate	Power supply cord is unplugged.	Plug into a grounded outlet.
	Household fuse is blown, or a	Replace the fuse or reset the circuit breaker. If the problem
	circuit breaker is tripped.	continues, call an electrician.
	The control displays an F9 or F9	The electrical outlet in the home may be miswired. Contact a
	E0 error code.	qualified electrician to verify the electrical supply.
Cooktop will not operate	The control knob is not set	Push in knob before turning to a setting.
	correctly.
	On ceramic glass models, the	See the control lock keypad feature in the “Feature Guide.”
	oven control lockout is set.
Excessive heat around	Cookware is not the proper size.	Use cookware about the same size as the surface cooking
cookware on cooktop		area, element or surface burner. Cookware should not extend
		more than ¹⁄₂" (1.3 cm) outside the cooking area.
Cooktop cooking results not	Control knob set to incorrect heat	See “Cooktop Use” section.
what expected	level
	Range is not level.	Level the range. See the Installation Instructions.
Cooktop element cycles on	Element cycling due to a	This is normal operation. The element may cycle on and off to
and off on High setting.	temperature limiter	keep the cooktop from overheating.
Oven will not operate	Delay start is set.	See “Cook Time” section.
	Control lock is on.	Press and hold START for 3 seconds to unlock.
	Control is in Demo Mode.	Press and hold START TIME for 10 seconds to exit Demo
		Mode. Demo Mode is used for display models in a showroom.
	Electronic oven control set	See “Electronic Oven Controls” section.
	incorrectly
Oven temperature too high or	Oven temperature needs	See “Oven Temperature Control” in the “Electronic Oven
too low	adjustment.	Controls” section.

Oven indicator lights flash	Power to range is turned on or
	restored.

See “Control Display” in the “Electronic Oven Controls” section. If the indicator lights keep flashing, call for service. See cover for contact information.

13