WARNING
|
| Explosion Hazard | |
|
| Use nonflammable cleaner. | |
|
| Failure to do so can result in death, explosion, or fire. | |
|
|
|
|
|
|
|
|
DOORS AND LEVELING | Possible Causes and/or Recommended Solutions | ||
|
|
|
|
Doors are difficult to open | ■ Gaskets are dirty or sticky - Clean the gaskets and contact surfaces with mild soap and warm | ||
|
| water. Rinse and dry with a soft cloth. | |
|
|
|
|
Doors will not | ■ Door is blocked open - Move food packages away from the door. Make sure all bins and | ||
close completely |
| shelves are in their correct positions. Make sure all packaging materials have been removed. | |
|
|
|
|
Doors appear to be uneven | ■ Doors need to be aligned, or refrigerator needs to be leveled - See the leveling and door | ||
|
| alignment instructions. | |
|
|
|
|
Refrigerator rocks | ■ Refrigerator is not level - To stabilize the refrigerator, remove the base grille and lower the | ||
and is not stable |
| leveling feet until they touch the floor. See the leveling and door alignment instructions. | |
|
|
|
|
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
ICE AND WATER | Possible Causes and/or Recommended Solutions |
Ice maker is not producing ice, not producing enough ice,
or producing small/hollow ice
■Refrigerator is not connected to a water supply, or the water supply shutoff valve is not fully turned on - Connect the refrigerator to a water supply and make sure the water shutoff valve is fully open.
■Kink in the water source line - A kink in the water line can reduce water flow, resulting in decreased ice production, small ice cubes, and/or hollow or
■Ice maker is not turned on - Turn on the ice maker. See “Ice Maker and Storage Bin.”
■New installation - After connecting the refrigerator to a water source, flush the water system.
(See “Water and Ice Dispensers.”) Wait 24 hours for ice production to begin. Wait 72 hours for full ice production. Discard the first three batches of ice produced.
■Large amount of ice was recently removed - Allow sufficient time for the ice maker to produce more ice.
■Ice is jammed in the ice maker ejector arm - Remove ice from the ejector arm using a plastic utensil.
■Inadequate water pressure - Verify that the household has adequate water pressure. See “Water Supply Requirements.”
■Water filter is installed incorrectly - Make sure the filter is properly installed. See “Water Filtration System.”
■A reverse osmosis water filtration system is connected to your cold water supply - This can decrease water pressure. See “Water Supply Requirements.”
NOTE: If questions remain regarding water pressure, contact a licensed, qualified plumber.
22
