Whirlpool W10726840A Style 2 - Contour Door Models, Refrigerator Door, A B A, Cabinet

Refrigerator Door

1.Remove the screw cover. See Graphic 6.

2.Remove refrigerator handle assembly, as shown. Keep all parts together. See Graphic 6.

3.Remove door hinge hole plug from refrigerator door. Move to opposite side hinge hole, as shown. See Graphic 3.

4.Remove door handle sealing screws. Move to opposite side of refrigerator door, as shown. See Graphic 4.

5.Remove door handle hole plug and discard. See Graphic 7. Replace on opposite side with the door handle hole plug provided in the Reversibility Kit located in the crisper.

6.Remove door stop. Move to opposite side of refrigerator door, as shown. See Graphic 5.

7.Position refrigerator handle on opposite side of the refrigerator door, as shown. See Graphic 6. First, drive top two screws in handle first. Align lower portion of handle and drive bottom screw into handle.

8.Tighten all screws. Set aside refrigerator door until bottom hinge is installed on refrigerator.

9.Replace screw cover. See Graphic 6.

Style 2 - Contour Door Models

Graphics follow these instructions.

Door Hinge	Cabinet Hinge	Setscrew	Door Stop
Hole Plug	Hole Plug		Screw
Dome Cap	Dome Cap	Shoulder	Flat-Head
	Washer	Screw	Handle
			Screw
	Shoulder	Door Handle
	Screw Washer	Hole Plug

Cabinet

1.Remove the three dome caps and screws from handle side and move them to opposite side. See Graphic 1-1.

2.Using the three ⁵⁄₁₆" hex-head hinge screws, insert two screws halfway into the holes, leaving space to insert the center hinge.

3.Slide the center hinge, from the right, onto the screws. Insert the third screw, and tighten all screws completely.

NOTE: Make sure the washers are in place on both the top and bottom pins of the center hinge.

A

B

A

A. ⁵⁄₁₆" Hex-head hinge screws

B.Washers

4.Remove cabinet hinge hole plugs from the cabinet top and move them to opposite side hinge holes, as shown. See Graphic 1-2.

Freezer Door

1.Remove the freezer door handle. Using a ¹⁄₈" hex key, loosen the setscrew located on the side of the handle. Pull the handle straight out from the door. Keep all parts together. See Graphic 2.

2.Remove the brand badge using the plastic tool (provided). Replace it with the badge provided in the Reversibility Kit located inside the crisper. For proper placement, see the Brand Badge Placement template (the last page of this manual).

NOTES:

■To avoid scratching the finish, do not use a sharp or metallic object to pry the brand badge from the door.

■Rub a small amount of liquid dish soap over any adhesive residue with your fingers. Rinse the door with warm water and dry with a soft cloth.

3.Remove door stop. Move to opposite side of freezer door, as shown. See Graphic 4.

4.Reinstall freezer handle on opposite side of the freezer door, as shown. See Graphic 2.

5.Tighten all screws. Set aside door until hinges and refrigerator compartment door are in place.

7