Whirlpool WU1000XO r SOLUTION, Dishes not dry, Black marks on dishes, Chipping or breaking, clean

PROBLEM CAUSED BY

Small particles deposited on items “Old” detergent (continued)

Not enough cleteigent. or nnpropei detergent

Water 1s not hot enough

Water pressure may be low. dishwasher IS not fillmg properly

Dishes not dry		No rinse		agent
		Water IS not hot enough
		Improper		loading
		Drying	without			heat
Black marks on dishes		Aluminum		utensils rubbing against
		items	during		washmg
Chipping or breaking	glassware	Improper		loading
Dishes not washing	clean	Water	is not		hot	enough

Improper loading

r SOLUTION

Use only fresh dishwasher cletergent Store tightly closed container m cool. dry place. Discard old detergent Do not fill dispensers until ready to start drshwasher.

Use more drshwasher deter-gent. Use detergent with highest available

phosphorus content especially with hard water

Water tempeiature should be at least 140 F (60 C) Set water heater thermostat to a higher setting. Run water at smk untrl hot before starting.

If water pressure is low, do not use water for other purposes whrle dishwasher is running (to assure correct fills).

Does the rmse agent dispenser need filling7 See instructions on page 5.

Water temperature should be at least 140 F (60 C). Set water heater thermostat to a higher setting. Run water at smk until hot before startmg.

Make sure dishes and glassware are loaded so spray reaches all surfaces and items dram properly. Do not overload. Do not nest items

Allow more time when drymg without heat, or dry with heat. Plastic items may need towel drying.

Use care m loading aluminum utensils, especially any lightweight foil container. Place so they do not touch dishes. Remove black marks with plastic scourmg pad and a mild abrasive cleanser.

Do not overload. Load glasses m the top rack only. Load between prongs, not over them. Glasses loaded over prongs will not be supported and may chip or break.

Water temperature should be at least 140-F (60 C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting.

Make sure dishes and glassware are loaded so spray reaches all surfaces and items dram properly. Do not overload. Do not nest items.

Make sure large items do not block spray from reaching detergent dispensers.

Page 8