Whirlpool WU4000, WU5750 Adding a dish during a cycle, setting, Canceling a cycle, Changing

For models with more than three buttons:

Push a Cycle Selector button for the desired
cycle. Use any Cycle Selector button with the
Rinse 8 Hold cycle. The Cycle Control knob
determines which cycle operates.	Cyclem may vary with models

3.Turn the Cycle Control knob clockwise to point to the desired cycle. See page 8 for cycle descriptions.

You will feel a definite stop at each cycle mark. The dishwasher will automatically start the cycle you selected.

NOTE: lf the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. Thii is normal and will not hurt the dishwasher. lf you prefer, you can set cycles with the door unlatched.

Adding a dish during a cycle

(model series WU3000 and WU4000, WUS750)

You can add an additional item to the dishwasher reaches LIGHT WASH. See page 8.

1.Lift up on the door latch to unlatch the door and stop the cyde. Wait a moment for the spray action to stop before open- ing the door.

2.Cpen the door and add the dish.

3.Close the door. Do not latch It.

anytime before the Cycle Control knob

Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

4.Press door in to latch it. The dishwasher will start where it stopped.

Changing	a cycle		setting
(model series WU3000 and WU4000, WU5750)
You can change a setting anytime during any cycle.
1. Lii up on the	door latch	to unlatch	the	NOTE: Turning the Cycle Control knob
door and stop the cycle.				may cauw	the	covered	section of the
2. Turn the Cycle Control		knob clockwise to		detergent	dispenser to open. Be sure to
the cycle you	want.			fill the covered		section,	and dose the
3. Check the detergent dispenser to be sure				cover, if the cycle uses detergent in
				both sections.
it is properly filled for the new cycle. See
page 10.			4.	Close and latch the door. The dishwasher
				will automatically start the new cycle.

Canceling a cycle

You can cancel a cycle anytime during the cycle.

1.Turn the Cycle Control knob &My clockwiie to the drain portion of the wash or rinse. You will hear water draining when you have advanced to the proper location.

2.Let the dishwasher drain completely.

3.Lii up on the door latch to unlatch the door.

4.Turn the Cycle Control knob dockwise point to OFF.

to

7