Fresh Food Storage
Sliding shelf |
Cantilever Shelf |
Combination Cantilever/Sliding Shelf |
(some models) |
Humidity Control |
Crisper Cover Support
Shelf Adjustment
Refrigerator shelves are easily adjustable to suit individual needs. Some models have sliding shelves, others have cantilever shelves. Before adjusting shelves, remove all food. The shipping clips that stabilize the shelves for shipping may be removed and discarded.
To adjust sliding shelves, remove by pulling forward to the stop |
| |
position, then lift the front edge up and pull out. Replace on any pair |
| |
of rails by reversing this procedure. |
| |
To adjust cantilever shelves (shelves supported at the rear of the |
| |
refrigerator), lift the back of the shelf up and out. Replace shelf by |
| |
inserting hooks at rear into slots. Lower and lock into position. |
| |
To adjust combination cantilever/sliding shelves, remove shelf by |
| |
lifting hook out of rear slot, and sliding shelf forward to the stop |
| |
position. Lift up front edge and pull out. Replace shelf by sliding shelf |
| |
back on supports, and inserting the hook into the respective middle | Remove | |
slot. | ||
Shipping Clips | ||
|
Door Storage
Door racks allow convenient storage of jars, bottles, and cans. Items used often are available for quick selection. Some models have door racks which can accommodate
NOTE: When storing
The Dairy compartment is warmer than the general food storage section and is intended for short term storage of cheese, spreads, or butter.
Crispers
The Crispers, located under the bottom refrigerator shelf, are designed for storing fruits, vegetables, and other fresh produce. Wash items in clear water and remove excess water before placing in the Crispers. Items with strong odors or high moisture should be wrapped before storing.
The Humidity Control (some models) allows you to adjust the humidity within the Crisper. This can extend the life of fresh vegetables which keep best in high humidity. Leafy vegetables, however, keep best when stored with the Humidity Control set on HIGHER, or in a drawer without a Humidity Control. This keeps incoming air to a minimum and maintains maximum moisture content.
Crisper Cover Support (some models)
The Crisper Cover Support, located between the two Crisper drawers, is shipped raised from the liner floor. This prevents damage to the liner floor during shipping. Once your refrigerator has been installed in it’s final location, the Foot of the Crisper Cover Support must be lowered to prevent bowing in the middle of the Crisper Cover, when food is placed on it.
Adjusting the Foot of the Crisper Cover Support:
1.To lower the Foot, rotate it the clockwise direction until it rests on the liner floor.
2.To raise the Foot, rotate it in the counterclockwise direction.
Meat Pan (some models)
Some models are equipped with a Meat Pan that can be positioned below any refrigerator shelf. Use this pan for short term storage of bulk meat items. If meats are to be kept longer than 1 or 2 days, they should be frozen.
7