Installation Steps

Installation Guide & User Manual

TELETALKER™ Model TEL 040

Step 1: Make sure you have a 115 VAC wall outlet and tele- phone jack within 6 feet of the place you’ve chosen to install the telephone. If you have an older 4-prong jack, you’ll need a modular jack adapter. These adapters are available from electronic, phone, and other retail stores.

Step 2: Place the Pulse/Tone Switch, located on the side of the phone, in either Tone or Pulse (Rotary Dial Pulse). Make sure you choose the correct dialing mode. Tone dialing will not work if you have only dial pulse (rotary) service.

fig. 2: Pulse/Tone Switch

Pulse / Tone Switch

Switches between touch-tone and rotary dial modes.

TO TEL. LINE	AC 12 V/0.85A
PULSE TONE

Step 3: Set Ringer Volume and Tone Controls to desired level. (see fig.3)

fig. 3: Ringer Controls

		HI	I	II	III
	LO		I		TONE
OFF			RINGER		TONE
OFF			RINGER
	RINGER

Ringer Volume Control	Ringer Tone Control
Adjusts ringer volume (Hi, Lo, Off)	Adjusts ringer pitch (I, II, III)

Step 4: Plug the coiled handset cord into the handset. Plug the other end into the telephone base. (see fig. 4)

Williams Sound TEL 040 user manual Installation Steps

Models: TEL 040