TELETALKER™ Model TEL 040 | Installation Guide & User Manual |
Bare Wall Installation
Even if you don’t have a studded wall phone plate, you can still mount the TELETALKER on any wall surface within six feet of a standard modular jack and AC outlet. To mount the phone farther from the jack you’ll need a longer line cord or a telephone exten- sion cord. In either case, place the AC power pack in a location which will not be subject to disturbance.
Step 1: Measure and mark the wall for mounting screws. Mark two points
Step 2: Install the mounting screws (not included).
Use wood screws for stud mounting, anchor screws for hollow wall mounting. Drive the screws almost com- pletely in, leaving a 1⁄8 inch space between the wall sur- face and the bottom of the screw head (about the thick- ness of two stacked pennies).
Step 3: Reverse the handset hanger to prevent the handset from falling.
Step 4: Mount the TELETALKER.
Hang the telephone on the mounting screws and push down gently until it snaps into place
Step 5: Connect the line cord to the jack on the top of the phone. Plug the other end of the line cord into a modular wall jack.
Make sure it snaps firmly into place.
Step 6: Connect the AC power pack to a wall AC outlet.
Step 7: Check for the dial tone.
If you can’t hear a dial tone, see In Case Of Difficulty, page 12.
Note: To disconnect the telephone, squeeze the clip on the modular plug and pull it out of the jack.
9
