Assembly
Tools needed for assembly:
•10mm
•
•Combination square, or similar angle measuring device.
Sander must be unplugged from power source during assembly.
Remove the protective coating from the surfaces of the sander and from any loose parts. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the table surfaces with a good quality paste wax.
Leave enough space around the sander for long workpieces and for general maintenance.
If needed, the sander can be bolted to a table or workbench using the holes in the base. If the sander has a tendency to walk or slide during operation, it must be bolted to a supporting surface.
Installing Belt Table
1.Unscrew the stud. See Figure 1.
2.Position the bracket of the belt table over the holes in the casting as shown, and
3.Place a flat washer onto a handle, and insert the handle through the table bracket and into the hole. Screw the handle all the way into the hole.
NOTE: The handle is spring loaded; screw the handle in by rotating clockwise, then pull outward on the handle. Rotate the handle back to position, then release it, making sure it seats itself upon the pin. Continue the process until the handle is tightened in the hole.
Installing Dust Chute
The sander has two
The dust chutes can be connected to a vacuum system to collect dust particles.
9
Figure 1
Figure 2
