Wilton 4103, 4126AC, 4106 manual Introduction, Setup and Operation, Installation of Work Rest

Introduction

This manual includes operating and maintenance instructions for the Wilton Model 4103, 4106 and 4126AC Square Wheel Belt Grinder. The manual also includes parts listings and illustrations of replaceable parts.

Refer to Figures 1 and 2 for key features of the Square Wheel Belt Grinder.

Setup and Operation

The Square Wheel Belt Grinder can be mounted on a work bench or an optional pedestal. The grinder should be secured to the work bench or pedestal using the four holes in the base of the grinder. (Refer to Assembly of Pedestal for machines that are to be pedestal-mounted.)

Installation of Work Rest

The work rest mounts on the left side of the head casting. Attach the work rest using the socket head cap screw provided with the machine.

The slot in the work rest has a lip against which the cap screw is tightened. Place the hole at the end of the slot over the cap screw. Then slide the rest inward until the work rest is in position in front of the contact wheel. Tighten the cap screw.

Belt Tension Lever	Belt Tracking	Inverter	Belt Tracking
	Adjustment		Adjustment
Motor	Upper		Upper
	Guard
		ON/OFF	Guard
		Switch
		Motor	7
Switch	Work
	Rest		Work
	Contact
			Rest
	Wheel		Contact
			Wheel
	Pedestal		Pedestal

Figure 1: Square Wheel Grinder Features	Figure 2: Square Wheel Grinder Features
(single speed)	(variable speed)