Vacuum Connection
NOTE: A variety of vacuum system options are available. (Refer to Accessories section.)
The grinder uses a front mounted vacuum system. Refer to Fgure 3. Install the vacuum system components as follows:
1.Slide the support bracket into the channel secured to belt grinder base. Install one knob in the belt grinder base to secure the support bracket.
NOTE: Refer to vacuum scoop exploded view, Figure 11 when installing channel.
2.Slide the ducted scoop onto the support bracket. Install remaining knob in the support bracket to secure the scoop.
3.Connect hose to exhaust duct and secure with a clamp.
8 |
Clamping |
Knob |
Support |
Bracket |
Scoop |
Clamping |
Knob |
Figure 3: Vacuum Connection
Electrical Connection
Refer to the Wiring Diagram section for wiring information. Connection to electrical power should be made by a qualified electrician. Observe local electrical codes when connecting the machine.
Operating Controls
Model 4103/4106
The ON/OFF switch for the Model 4103/4106 grinder is located in a switch box mounted on the drive motor.
Model 4126AC
NOTE: Refer to Figure 4. Use only the inverter controls defined in the following procedures. The inverter is
Press the FWD RUN pushbutton on the inverter and set the speed using the up/down arrow keys (to the right of the speed display). Press the up arrow to increase speed; press the down arrow to reduce speed. The display on the inverter shows drive motor speed in revolutions per minute. Press the STOP button on the inverter to stop the grinder. Then set the ON/OFF switch to OFF.
| STOP | |
| Button | |
FWD (For- | Up | |
Down | ||
ward) Button | ||
| ||
On/Off |
| |
Switch |
| |
Speed Display |
| |
(RPM) |
|
