Wilton FK350-2SX, FK350-4 manual Operation, FK350-SX

Operation

Before using the machine:

‰Check that safety devises (ex., blade guards) are in position and work perfectly and that personal safety requirements are complied with.

‰Check the sharpness of the blade and verify coolant flow.

FK350

1.Make sure the work piece is securely clamped in the vise.

2.Turn the power on (A, Fig. 8).

3.Select the cutting speed (B, Fig. 8).

Figure 8

4.Grip the trigger handle (Figure 5) on the control lever.

5.Start the blade by pressing the micro-switch on the handgrip.

The down stroke speed of the head is controlled manually by the operator. The coolant pump is activated during the time that the head is below the upper limit position.

When the cut is complete:

6.Raise the head.

7.Remove the work piece from the vise using the vise hand wheels.

FK350-SX

To operate machine,

1.Clear the Emergency Stop.

2.Press Control On.

3.Select the desired blade speed.

4.Select Manual or Semi-auto.

Manual Mode – Position material and tighten the vise. Position the head switch to Head-Down until cut is complete. Position the head switch to Head-Up until head retracts to desired height.

Semi-auto Mode – Set the head travel trips to achieve desired head travel extents. Position material in the vise allowing approximately .125" for proper air vise operation, and then press cycle start. After the cycle is complete, the vise opens for material repositioning.

Note: The coolant pump is activated while the motor is running.

Figure 9

11