Installation
Unpacking the machine
Do not handle the packed machine using slings.
To install the machine, first remove the packing, paying particular attention not to cut any electric wires or hydraulic hoses. Lift using straps (Figure 3).
Figure 3
Anchoring and handling the machine
The base of the machine must be anchored to the floor by two lag bolts or studs properly anchored into concrete.
Electrical Connections
All electrical connections must be done by a qualified electrician. All adjustments or repairs must
be done with the machine disconnected from the power source, unplugged. Failure to comply may result in serious injury!
These machines not supplied with a plug. Use a plug and outlet rated at least 20amps. The circuit for the machine should also be protected by at least a 20 amp circuit breaker or fuse.
Make sure that the blade turns in the correct direction. If it does not, simply reverse two of the phase wires on the supply input.
The sawing machine is now ready for use.
9
