1ft.
(30cm)
OFF
STEP
1
STEP
2
CLEANING PROCEDURE
Start at wall closest to power outlet. Pull straight back without pushing down on handle.
Release intermittent setting or turn off continuous setting on brush/spray switch approximately 1 foot before ending cleaning pass.
1in.
(25mm)
SOLUTION
INTAKE COVER
VACUUM
INTAKE COVER
STEP
3
STEP
4
Push down on handle to raise vacuum shoe and brush before moving to the next cleaning pass. Overlap brush contact area approximately 1inch.
During operation, observe the following: The Cadet is equipped with clear internal covers to facilitate operator viewing of dirty solution and vacuum air flow.
During operation, observe the vacuum intake cover. Large amounts of water or foam entering the vacuum system can damage the vacuum motor. If you notice either condition, shut down the machine immediately. Empty recovery tank and/or add defoamer to recovery tank.
CADET 86038220 03/16/07 |
