TROUBLESHOOTING CHART
PROBLEM | CAUSE | |
No Power, Nothing | Is the cord plugged in. | |
Circuit breaker tripped in building. | ||
Runs | ||
Faulty switch. | ||
| ||
| Faulty power cord or pigtail. | |
| Vacuum circuit breaker tripped. | |
Vacuum Motor Will Not | Faulty main vacuum switch. | |
Run | Loose wiring. | |
| Faulty vac motor. | |
| Carbon brushes worn. | |
|
| |
| Debris lodged in vac shoe. | |
Vacuum Motor Runs | Dome gasket defective or missing. | |
But | .Vacuum hose cracked or hose cuff loose. | |
Suction Is Poor | Recovery tank full / float ball stuck in the | |
| up position. | |
| .Main pump switch off. | |
Poor Or No Water Flow | Jets clogged or missing. | |
(Carpet Is Streaky) |
| |
| Solution filter clogged. | |
|
| |
| Faulty solenoid. | |
Brush Does Not Spin | Brush switch off. | |
Brush circuit breaker tripped. | ||
| ||
| Brush belt broken. | |
| Faulty brush motor. |
SOLUTION
Plug in cord. Reset breaker. Call for service. Call for service. Reset breaker. Call for service. Call for service. Call for service.
See “Brush Replacement” in maintenance section. Remove debris from vac shoe. Replace as necessary. Replace or repair as necessary. Turn off vac motor. Drain and rinse recovery tank.
Turn on.
Clean using a vinegar /water solution or replace.
Drain solution tank and clean solution filter.
Call for service.
Turn on brush switch. Reset circuit breaker. Replace as necessary. Call for service.
ADMIRAL 86038230 03/16/07 |
