SERVICING THE VAC MOTOR
Vote: When replacing carbon vac motor
brushes loosen wire terminal BEFORE
removing screws on bracket
f armature commutator is not concen- tric, extremely pitted, or grooved the motor will need to be replaced or sent to a qualified service center to restore vac performance.
Important:
These brushes wear quicker as the length shortens due to increased heat.
Spring inside brush housing will damage motor if brushes are allowed to wear away completely.
Note:
(actual size) -
Periodically check the length of the carbon brushes. Replace both carbon brushes when either is less than 3/8” long.