6.Lower machine to floor. Dispense solution by using either the continuous pump switch or the intermittent pump switch. Use the continues pump switch for large open areas. Use the intermittent pump switch for small confined areas. Walking backwards, move the extractor over the area to be cleaned. The ex- tractor’s brush assistance allows the machine to moved quickly and easily over the carpet. Remember to turn off the pump switch about six inches before the end of each pass.
7.As you work check for foam building up in the recovery tank. If foam is building up stop and add the recommended amount of defoaming compound to the recovery tank.
Never put defoaming compound in the solution tank!
WARNING:
An overflow of foam from the recovery tank into the vacuum intake can damage the vacuum motor. Always be aware of the waste water level in the recovery tank. When the tank is about three quarters full, turn off the machine, bring the machine to a floor drain, and drain the recovery tank using the convenient drain hose located at the rear left corner of the tank.
a.As the extractor begins to run out of cleaning solution it will start streaking and won’t completely clean the carpet. When the extractor runs out of cleaning solution turn off the machine, drain the recovery tank as described above, remove the dome and recovery tank, and refill the clean solution tank.
9.Ventilate the area which has been cleaned. Keep children and pets away and prohibit traffic until carpet is completely dry.
To Use an Accessory Tool:
1.Turn the machine completely off and unplug it from electrical outlet.
2.Turn solution valve to “Accessory Tool Position”.
3.Remove recovery hose (white cuff) from dome and insert hose from accessory tool in its place.
4.Attach solution hose from accessory tool to the “Accessory Tool Solution Connection”located on the upper right back of the chassis.
5.Make sure the solution tank has solution and that the recovery dome and tank are in place and ready for operation.
6.Plug the machine in and turn on only the vac/pump switch.
CAUTION:
Using accessory tool with brush switch on may damage floor
7.Make sure the solution valve is returned to the “Carpet Spray Position”before returning the ADP to standard carpet extraction.
6.Turn off the machine and unplug it from electrical outlet before disconnecting accessory tool.
Approved Accessory Tools:
Standard Floor Wands
(SFW, SW, or
Deluxe Hand Tool (DHT)
Upholstery Hand Tool (UPH3)
6 | 98198 | 7/l/97 |
