Pitney Bowes DM900, DM800 E-Z Seal Sealing Solution Maintenance, Filling the Moistener Bottle

9 • Maintaining and Updating

E-Z Seal®

Sealing

Solution

Maintenance

Your mailing system displays a message telling you when your E-Z Seal® Solution is running low. When you receive this message, your system can still seal approximately 50 envelopes.

CAUTION:

•Pitney Bowes recommends using E-Z Seal® Solution because it helps keep your moistener tank clean and improves sealing efficiency. To order E-Z Seal® Solution, refer to Chapter 11, Supplies and Options in this guide.

•Do not overfill the E-Z Seal® bottle.

•Make sure you do not spill any solution in the tape well. If the tape gets wet, it can warp and cause a jam.

Filling the Moistener Bottle

1.Open the moistener cover and lift out the flap moist- ener bottle..

2.Remove the cap from the bottle.

3.Add enough E-Z Seal® to bring the level up to the bottom of the fill cap.

4.Replace and tighten the cap and return the bottle to its original position.

5.Close the main cover.

Moistener Cover

Moistener

Bottle

Cleaning the Moistener Brush

1.Move the tape lever to the up position and open the

	side door.	"
2.	Pull the brush mecha-
	nism forward and hold as
	shown at right (A).
3.	Remove the bruse case
	as shown in the illustra-
	tion at right (B).
4.	Rinse the brush under
	cold water, separating the

bristles to remove excess	!
glue and deposits.

9 - 4 SV60861 Rev. F