Pitney Bowes DM800 manual Adding, Postage Pass - Automated Postage Refill, Don’t Print Receipt

DM800™, DM900™ Digital Mailing System Operating Guide

5	Adding	To add postage from your Postage By Phone® System account to your
	Postage	postage meter, follow these steps.

1.Press the Funds key.

2.Select Quick Refill, or Other Refill Amount.

3.If you have set up a supervisor password, you are prompted to enter the password now.

Enter the password and press the Enter key.

4.If you select Quick Refill, the system adds the same amount it did the last time you added postage.

5.If you select Other Refill Amount, use the number keys and enter in the amount you want to add (up to $1000). Use whole dollars only; do not key in cents. Your meter automatically adds two decimal places.

6.Press the Enter key. The system dials Pitney Bowes to connect to your account and begins to add the postage to your meter.

7.The system notifies you when it finishes adding your postage and dis- plays the message “Refill Complete”. The system prompts you to down- load an available update or:

•Press Tape to Print Tape

•Press Start to Print an Envelope

•Don’t Print Receipt

8.Select the appropriate option.

NOTE: To view or print a statement showing the details of the last five times you added postage to your meter, press the Reports key on the control center and select Last 5 Refills. Refer to Chapter 8, Reports in this guide for details of all system reports.

6Postage Pass - Automated Postage Refill

With this feature, you determine the amount of postage you want trans- ferred to your meter during each refill and you choose the dollar amount at which you want a refill to occur. When the postage balance in the meter drops to the amount you’ve set as the low funds value, the meter automati- cally downloads the amount you preset. Your meter is always ready for use.

IMPORTANT: This feature requires a constant connection via one of three methods:

•direct analog phone line,

•wireless connection using an analog device (see below), or

•LAN connection using an approved Ethernet device.

When this feature is enabled, your system will automatically initiate contact with Pitney Bowes to refill your meter according to the values you establish in the system. Your mailing system will only initiate a refill when the system powers down (Sleep Mode), wakes up (if it was turned off), or if your post- age meter runs low on funds. Your system will not initiate a refill during a transaction, or in-between transactions. This ensures that your normal operations will not be interrupted.

When your system automatically connects, it will also check to see if any other tasks are necessary during the same connection. This includes uploads of tracking records, electronic postal inspection, or other functions performed during the refill. If an update is required, you will be prompted to do so at that time.

SV60861 Rev. F 6-7