BRUSH MOTOR REMOVAL
1.Turn off switch and unplug machine.
2.Set the machine in its upright position. Remove the screws (2) in the back metal cover. Rotate the cover down and slide back releasing the tab under the machine from the main frame.
3.Remove the pump box cover. Remove screws
(4) at each leg of the cover.
4.To remove brush motor, position the machine to have access to the bottom. Remove screws (2) at the sides of the machine holding the brush deck pivot axle.
5.Remove screw mounting belt cover and remove belt cover.
6.Remove the nuts and washers (2) at brush motor and slide motor forward to reduce belt tension. Remove belt.
7.Remove pulley by loosening set screw and pull off shaft.
8.Unplug the brush motor wires from the rectifier located in the pump mount housing. Also, remove the ground lug from the stud on the main frame by removing the nut on the stud.
9.Reverse the process to reinstall the motor. Align motor pulley with brush pulley. Check belt for proper belt tension.
MAINTENANCE
PUMP REMOVAL
1.Turn off switch and unplug machine.
2.Set the machine in its upright position. Remove the screws (2) in the back metal cover. Rotate the cover down and slide back releasing the tab under the machine from the main frame.
3.Remove the pump box cover. Remove screws
(4) at each leg of the cover.
4.To remove either pump, loosen the hose clamp and remove the hose from both ends of the pump.
5.Remove screws and washers (4) that mount pump housing.
6.Unscrew the hose fittings from each end of the pump.
7.Flex the pump mounting housing to remove the pump.
8.Remove the screw attaching the ground wire to the pump. Remove the other two wire connectors attached to the pump.
9.Reverse the process to reinstall the pump.
86037780 EXTRACTOR 11/21/07 |
