DISH Receiver Setup
If using two DISH receivers with the Carryout G2
antenna, both receivers must be configured off of the primary port by following the steps below.
1.Disconnect coax cable from the Satellite In port on the back of the receiver.
Satellite In
port
Back of 211z receiver shown
2.Press Menu on your remote. Select option 6, System Setup.
3.Select option 1, Installation.
4.Select option 1, Point Dish.
5.Select Check Switch.
6.Select Test. It will go through a number of steps, then return to the screen shown here with previous information cleared. If at any point it asks you to save, select Save or Yes.
7.Reconnect coax cable to “Sat In” port on back of receiver. Power on the antenna. Allow the antenna
8.Check that there are no checkmarks by SuperDISH or Alternate. If setting up a DISH 311, 301, or 500 series receiver, in some cases you may need to check the boxes next to Superdish and Alternate before running the Check Switch test.
9.Next, select Test again to install the SW64 switch. This SW64 switch is a DISH receiver setting, not a physical part.
10.When you see the SW64 as the installed switch, the antenna is ready for use.
4