Operation
Your new MV-0055 features:
•GPS technology
•Fast signal acquisition times
•Easy
•Ability to toggle between satellites using remote control, if subscribing to multi-
To operate your system —
NOTE: For Model
1.Turn on receiver and television set. This unit will not operate unless receiver is on. Be sure your TV is turned to channel 3 or 4.
2.Turn +12VDC power switch to ON position.
3.Allow up to 3 minutes for signal location. Sat- ellite signal acquisition will occur with normal operating conditions.
satellite programming
•Low maintenance
•Compatible with most digital satellite receivers
•Winegard warranty
NOTE: Acquisition time will be longer if the vehicle has traveled more than 600 miles without the unit in use.
If you have traveled this distance without using the unit, signal acquisition may take up to five minutes.
4.If you do not have a signal after three minutes, be sure there are no obstacles preventing signal acquisition. (Trees, hill, buildings or other structures can block the signal.) Move to an open area so your system can “see” the satellite signal.
5.If you do not have signal, see Troubleshooting, p. 10.
To toggle between satellites when subscribing to
The
When a channel is selected on the remote con- trol and it is not located on the satellite the unit is currently on, the system on the vehicle will automatically move to the new satellite.
DIRECTV programming
1.There is NO SETUP required for DIRECTV. When you request a channel located on a differ- ent satellite, the unit will automatically move to that satellite.
DISH Network programming
NOTE: This must be a DISH 500 system. These steps must be done each time the receiver is turned off.
1.Let unit acquire the satellite signal on satellite 119.
2.After signal has been acquired, press the MENU key on the remote control or receiver.
3.Go into the SYSTEM SETUP menu.
4.Go into the INSTALLATION menu.
5.Go into the
6.Scroll down to the CHECK SWITCH button and select.
7.The receiver will verify that you want to perform a “Check switch.” Select CHECK.
8.The receiver will begin checking your switch by tog- gling between transponders. When this is completed, a message stating “satellite reception is verified” will show. When it does, select OKAY. If this message does not ap- pear, repeat steps 1 - 7.
9.Your system is now set up to toggle between satellites. It will automatically move to correct satellite when chan- nel is selected.
8
