Winegard SK-1000 Manual Operation, Enter User Menu? Search Mode, Multi-Sat Mode Manual ##

Manual Operation

The TRAV’LER antenna is a versatile satellite antenna and can be manually set to find many different satellites individually. This function is rarely used. The instructions assume that the antenna is already in the stowed position. Note: Diagnostics and Installation menus are not required for normal operation and should only be entered by a trained professional.

1.Press and hold “POWER” for two seconds or until the TRAV’LER interface displays “POWER ON.” Then, press and hold “ENTER for two seconds.

2.The interface will ask if you wish to enter the user menu. Press the Select button to choose “Yes,” and then press the Enter button to confirm the selection.

3.The user menu consists of four choices: Search Mode, Diagnostics, Installation, and Exit. Press the Enter button to choose Search Mode.

WINEGARD COMPANY	Enter User Menu?	Search Mode*
POWER ON	*Yes No	Diagnostics

4.In the Search menu, choose from the following: Multi-Sat Mode (normal search mode), Manual 110, Manual 119, Manual 129, Main Menu (returns to the user menu) or Exit (enters the search routine). (Note: Manual 82 and 91 will be options for Bell TV users.) Press the Select button to cycle through satellites until the asterisk is next to the satellite you wish to find. Press “ENTER” to confirm the selection.

5.The interface will ask you to confirm the change. Press “SELECT” to move the asterisk to “Yes.” Then, press “ENTER” to confirm the selection.

The TRAV’LER interface will then acknowledge which satellite has been selected. Press the Enter button.

6.The interface will ask if you want to turn the power off. Press the Enter button to choose “No” and start a new search for your chosen satellite. Press “SELECT” then “ENTER” to choose “Yes” and turn off the antenna.

The TRAV’LER antenna will remain in manual mode until you select “Multi-Sat Mode” again.

Multi-Sat Mode*	Manual ##
Manual 61	Selected

Power OFF?

*Yes No

DISH Receiver Setup

The following instructions assume that the TRAV’LER antenna has found and locked onto satellites 110°, 119°, and 129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface. The following instructions are based on a ViP® 211 receiver. If your receiver differs from the options shown below, you may need to consult your receiver manual. The wording and display used in yoru receiver may differ slightly.

Check out online receiver setup guides for your antenna at www.winegard.com/receivers/setupguide.php.

1 2 3

Press “Menu” on your remote. Select option 6, “System Setup.”

Select option 1, “Installation.” Then,	Select “Check Switch.” Continue
select option 1 again to choose	with step 4 on the next page.
“Point Dish.”

3