Winegard SK-1000 Before Installing the Antenna, Specifications, Safety Recommendations

Before Installing the Antenna

You have selected the Winegard® TRAV’LER® automatic multi-satellite TV antenna. The TRAV’LER antenna will deliver the ability to view multiple satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy to use functionality—just like you get at home. This manual provides important information on the installation and operation of your TRAV’LER antenna on an RV. Please take time to read the manual in its entirety before installing or operating your antenna.

Follow the instructions on this side of the manual if installing the TRAV’LER DISH/Bell TV antenna. For operation instructions, follow the instructions on the reverse side of the manual.

Specifications

Depending on location and DISH receiver type, the following satellites can be accessed with the SK-1000 during automatic operation: 110°, 119°, 129°. Depending on location and Bell TV receiver type, the following satellites can be accessed with the SK-1000 during automatic operation: 82°, 91°.

Height of assembled unit: 9.75”	Width of mount base: 21”		Unit Weight: 45 pounds
Width of assembled unit: 25”	Length of mount base: 24”		Shipping Weight: 70 pounds
Length of assembled unit: 42”
		42″

23.5″

″	″
21	24

25″

FIGURE 1. Dimensions of SK-1000

Safety Recommendations

Do not attempt to install this system in the rain or under any wet conditions. Moisture may affect electronics and void your warranty.

Do not paint this antenna. Painting the TRAV’LER antenna will void your warranty.

Pay attention to the pinch points as the antenna raises. The pinch points should be labeled on the antenna (see fig. 2).

Pinch point (labeled) Pinch point (labeled)

FIGURE 2. Pinch points

1