Wolf Appliance Company CT30I/S Induction Cooktop Operation, Hi-Power Mode, Hot Surface Indicator

Induction Cooktop Operation 12

Cooktop Operation

HI-POWER MODE

Hi-Power mode boosts power on one induction element by diverting power from an adjacent element. This mode is suitable for frying foods or boiling water rapidly.

To activate Hi-Power mode, touch the OFF ON touch pad for the element you wish to use. Then touch HI-POWER. Power from an adjacent element will automatically be diverted to the element. If the adjacent element is on HIGH power, the power output will be reduced. This reduction in power will be displayed in the power bar indicator of the adjacent element.

HOT SURFACE INDICATOR

As a safety precaution, a hot-surface indicator light will illuminate when the surface temperature of any one of the induction elements rises above 150°F (65°C). ‘HOT’ will illuminate in the control panel display. It will remain illumi- nated until the entire surface temperature has lowered to a safe level, even after the cooktop controls are turned off.

TIMER OPERATION

The induction cooktop features a countdown timer located in the control panel. Refer to the illustration below.

							HIGH
							FON
							F
							O
						IM	ER
							OW
						S	HI-P
						H
						G
						HI
			FON
			OF		ER
							EAR
		M			W
				PO			L
		SI	HI-				C
HIGH							O
ON							H
OFF							HIG
ELT						ON
M						FF
						O
						LT
					ME
		HIGH
	ON
	OFF	ER
IM		OW
	I-P
S	H
						HI-POWER
						TOUCH PAD

Hi-Power mode (CT36I/S shown).

The timer may be set in one-minute increments up to 99 minutes. Once set, the remaining time will be illuminated in the control panel as it counts down. The timer can be used anytime the cooktop is not in lock mode.

•To start the timer, touch + on the timer control. Touch and hold + or – until the desired time is shown in the timer display. The timer will begin its countdown in minutes, 3 seconds after the time is set.

•A warning chime will sound when the timer has one minute left and begins to countdown in seconds.

•When the timer reaches 0, an audible chime will sound. The chime will continue to sound every 30 seconds until CLEAR is touched.

						HIGH
						FON
						F
						O
					IM	ER
						OW
					S	HI-P
					H
					G
					HI	F
			FON
						OF
			OF		ER
		M			W	EAR
				PO		L
		SI	HI-			C
HIGH						O
						H
						HIG
					ON
					FF
					O
					LT
					ME
		HIGH
ON
OFF		ER
		W
	-PO
HI
						HOT-SURFACE
						INDICATOR LIGHT

						HIGH
						FON
						F
						O
					IM	ER
						OW
					S	HI-P
					H
					G
					HI	F
			FON
						OF
			OF		ER
		M			W	EAR
				PO		L
		SI	HI-			C
HIGH						O
						H
						HIG
					ON
					FF
					O
					LT
					ME
		HIGH
ON
OFF		ER
		W
	-PO					+ AND –
HI
						TOUCH PADS
					CLEAR
					TOUCH PAD

Hot-surface indicator. Timer control.