Warming Drawer Use & Care
Service Information | 9 |
| wolfappliance.com |
Cleaning and Care Recommendations
Troubleshooting | Service Information |
IMPORTANT NOTE: Make sure the warming drawer is off and all surfaces are cool before cleaning any part of the unit.
STAINLESS STEEL
DRAWER RACK
Clean the chrome rack with a mild detergent and water. After cleaning, rinse with clean water and dry thoroughly with a clean cloth.
If your Wolf warming drawer is not operating properly, use the following troubleshooting guide before calling your Wolf dealer. This guide will save you time and trouble and may help you avoid the expense of a service call.
When requesting information, literature, replacement parts or service, always refer to the model and serial number of your Wolf warming drawer. This information is found on the product rating plate located on the left front floor area of the inner cabinet. To access the rating plate, the drawer must be fully open. For location of the rating plate, refer to
Although stainless steel is resistant to most stains, it is not totally impervious to damage. Salt and some cooking liquids may pit and stain the surface. Always remove these spills immediately.
Use a spray degreaser to remove fingerprints and greasy spatters. Spray on a cloth and wipe surface. Buff dry immediately to avoid streaking.
For hard water stains, use white vinegar and water.
Do not use abrasive cleaners; they will permanently scratch the surface. Do not use steel wool pads.
STAINLESS STEEL DRAWER FRONT
To clean the exterior of the classic stainless steel drawer front, use a soft, nonabrasive stainless steel cleaner and apply with a soft
To bring out the natural luster of the stainless finish, lightly wipe the surface with a
IMPORTANT NOTE: Under no circumstances should you use a metallic or highly abrasive cleaner or cloth.
CONTROL PANEL
Be careful not to soak the control panel. Although the panel is sealed, excessive moisture may cause damage to the controls.
Use a glass cleaner to remove fingerprints and spills from the surface of the control panel. Spray first on a cloth before wiping the panel.
Warming drawer does not operate.
•A fuse may be blown or the circuit breaker tripped. Replace the fuse or reset the circuit breaker.
•Verify that the warming drawer is plugged in.
Drawer does not slide smoothly.
•Ball bearings are out of alignment. Fully extend the drawer and close completely to realign.
•Drawer is overloaded or the load is unbalanced. Reduce weight to less than 34 kg or redistribute contents.
There is excessive condensation.
•Remove liquid in the warming drawer pan.
•Cover food with a lid or aluminum foil.
•Temperature setting is too high, use a lower setting.
No heat in the proof setting.
•Room temperature may prevent the thermostat from turning on. Verify that PROOF is illuminated in the LCD display on the control panel.
Food dries out in the proof setting.
•Cover food with a lid or aluminum foil.
the illustration on page 6. Record the rating plate informa- tion below for future reference.
Model Number:
Serial Number:
Installation Date:
Wolf Dealer:
Phone:
The information and images in this guide are the copyright property of Wolf Appliance, Inc. Neither this guide nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Wolf Appliance, Inc. ©Wolf Appliance, Inc. all rights reserved.
