1023596 HOSE KIT
General Description
These instructions are for operating the LU126 loader using the tractor hydraulic remote control lever. To use this hydraulic connection, the tractor must be equipped with four tractor hydraulic couplers.
NOTE: Male quick couplers (3) for connection to trac- tor are NOT included with the hose kit but are avail- able as service parts.
Install Hose Fittings
1.Attach elbow (2) and male quick coupler (3) to each loader supply hose (1).
2.Connect loader supply hoses to loader steel feedlines. Following pattern shown in Figure 8.
1.1023472 Hose, 170" x 3/4 JICM x 3/4 JICM
2.313053 Elbow, 3/4 JICF x 1/2 NPTM
3.66511 Quick coupler, male 1/2
Figure 28. LU126 Loader Supply Hose Connection
Route Hydraulic Hoses
Route hoses along loader mount, under the right side of the operator’s platform, and over the rear axle.
Be sure to avoid contact with
Hoses must be routed so they are not pinched, bent sharply, or chafed during operation. Hoses must not interfere with any tractor control operation or contact any moving parts.
Connect hydraulic hoses to tractor hydraulic couplers.
Install Hose Hanger
1.Install hose hanger bracket beneath right side of the operator’s platform as shown in Figure 29. Use cap screw, flat washers, and lock nut as shown in Figure 29.
2.Route hoses through support and secure with lock pin (12).
+26(
+$1*(5
Figure 29. Hose Hanger Installed
4.58033 Hose hanger bracket
12.58047 1/4 x
15.6778 5/16 NC Lock nut
16.6250 5/16 NC x
17.4378 5/16 Standard flat washer
MAN0064 (Rev. 7/20/2007) | Hydraulic Installation 19 |
|
|
