Woods Equipment 111877 manual Hydraulic Installation, Hose Kit, Notice, General Description

1023582 HOSE KIT

General Description

These set up instructions are for operating the LU126 loader using a single lever control valve mounted to the right loader mount bracket as shown in Figure 21. To use this hydraulic connection, hose kit 1023582 must be connected between loader control valve and tractor hydraulics.

Install loader control valve before proceeding.

NOTICE

■If hydraulic lines are not connected as shown in this manual, the control valve may be damaged. A blocked outlet (RETURN) or improper hose con- nection will cause pressurized oil to enter the return circuit and damage the valve.

DP8

Figure 21. Control Valve Installed

Install Adapter Plate

NOTICE

■Removal of the accessory plate or remote valves with a load being held on the 3-point hitch will result in escape of high pressure oil and sud- den, uncontrolled drop of 3-point hitch arms.

Before attempting to install this kit, the following must be observed:

●Shut off engine, place transmission in neutral, and apply parking brake.

●Fully lower any equipment supported by the trac- tor remote hydraulic valves, if so equipped. Acti- vate any remote valves to relieve all hydraulic pressure in the remote circuits.

●Fully lower the 3-point hitch.

1.Thoroughly clean the top front of the hydraulic accessory plate.

2.Install elbow (12) and adapter (21) to adapter plate (2).

3.Remove accessory plate cover (A). Be careful not to disturb the O-rings that need to stay with the cover plate when it is removed.

4.Install O-rings to bottom of adapter plate (2). Use petroleum jelly to keep the O-rings in the counterbores.

5.Place the adapter plate over hydraulic opening.

6.Place the accessory plate cover onto the adapter plate. Make sure O-rings stay in the counter- bores.

7.Secure with hex head cap screws and flat washer as shown in Figure 22.

Figure 22. Adapter Plate Installed

A.----- Accessory plate cover

2.1001421 Adapter plate

10. 1001423 7/16 NC X 4-3/4 HHCS

12.316004 Elbow, 3/4 JICM x 3/4 ORBM 90°

15.21549 7/16 NC x 3 HHCS

16.21548 5/16 NC x 3-1/4 HHCS

19.4378 5/16 Standard flat washer

21.61 Adapter, 3/4 JICM x 3/4 ORBM

16 Hydraulic Installation MAN0064 (Rev. 7/20/2007)