3. Quick Start

This Quick Start procedure is included primarily to provide a quick demonstration of IPS capabilities. In order to take full advantage of the complete range of features provided by this unit, it is strongly recommended that you should complete the Installation and Configuration sections after completing the Quick Start procedure.

3.1. Hardware Installation

Make the following connections as described in Figure 3.1.

1.Switched AC Outlet: Connect the power cable from the switched device to the Switched AC outlet on the back panel of the IPS Master Unit.

2.Power Inlet: Connect the supplied power cable to the Power Inlet on the back panel of the IPS Master Unit. Connect the other end of the power cable to an appropriate power supply.

CAUTION: Make certain to review the safety precautions listed in Section 4.1.

3.10BaseT (Network) Port: Connect your 10Base-T or 100Base-T network interface to the IPS Network Port. For more information, please refer to Section 4.4.

Note: The IPS features a 10Base-T Interface. When connecting to a 100Base-T interface, most router switches will autosense to determine if the device is 100Base-T or 10Base-T, and then configure the network interface accordingly. If your router switch does not autosense, the network interface port must be manually set to 10Base-T.

4.Network Cable: Your 10Base-T or 100Base-T network interface.

3-1

Page 11
Image 11
Western Telematic IPS-15 manual Quick Start, Hardware Installation