To invoke On/Off/Bootcommands or view plug status via the Web
Browser Interface, proceed as follows:
1. Accessthe IPS-15 Command Mode as described in
Section 5.2.1.
2. Whenthe Plug Status Screen (Figure 6.1) appears, note that
the screen includes a status field and On/Off/Boot controls for
every satellite unit that was connected at the time that the
master unit was powered up.
3. Switching Plugs On: To switch one or more plugs On click
the "On" radio button next to the desired plug(s), and then
click on the "Apply" button.
a) Toswitch all Plugs On, click on the "On" radio button in
the "All Plugs" line, and then Click "Apply."
b) The IPS will display a screen which indicates that the
switching operation is in progress, and then return to the
updated Plug Status Screen (which should now show the
selected plugs in the On position.)
4. Switching Plugs Off: To switch one or more plugs Off, click
the "Off" radio button next to the desired plug(s), and then
click on the "Apply" button.
a) Toswitch all Plugs Off, click on the "Off" radio button in
the "All Plugs" line, and then Click "Apply."
b) The IPS will display a screen which indicates that the
switching operation is in progress, and then return to the
updated Plug Status Screen (which should now show the
selected plugs in the Off position.)
5. Reboot Cycles: To initiate a Reboot Cycle, click on the
"Boot" radio button next to the desired plug(s), and then click
on the "Apply" Button.
a) Toreboot all Plugs, click on the "Boot" button in the "All
Plugs" line, and then Click "Apply."
b) The IPS will display a screen which indicates that the
Reboot Cycle is in progress, and then return to the Plug
Status Screen (which should now show the selected plugs
in the On position.) Note that if different Boot Delay
Times have been assigned to each selected Plug, then the
Plug Status Screen will not be redisplayed until the
longest defined Boot Delay Time has elapsed.