Western Telematic IPS-15 Installation, Power Supply Connection, Connection to Switched Outlets

4. Installation

This section provides further details regarding the connections that are made in the process of installing the IPS-15. For a brief description of the overall installation procedure, and a connections diagram, please refer to Section 3.

4.1. Power Supply Connection

Use the supplied power cord to connect the IPS-15 Master Unit to an appropriate power supply. The Master Power Switch on the IPS back panel must be "On" in order for the IPS to operate. Note that if your installation will include optional IPS Satellite Units, then this procedure should be repeated for each Satellite Unit in the chain.

CAUTIONS:

•This device should only be operated with the type of power source indicated on the instrument nameplate. If you are not sure of the type of power service available, please contact your local power company.

•Reliable earthing (grounding) of this unit must be maintained. Particular attention should be given to supply connections when connecting to power strips, rather than directly to the branch circuit.

•Check nameplate ratings to ensure that there is no overloading of supply circuits that could have an effect on overcurrent protection and supply wiring.

4.2.Connection to Switched Outlets

Connect the power cord from the Switched Device to the Switched AC Outlet on the IPS Master Unit's back panel. When the unit is powered On, the Switched AC Outlet will be switched "ON" (this also applies to the switched outlets on any optional IPS Satellite units) . The Switched Outlet can switch up to 15 Amps AC. If your installation will include IPS Satellite Units, then repeat this

procedure for each Satellite Unit. 4-1