Western Telematic IPS-15 manual Plug Status Screen Text Interface

IPS-----InternetPlug"/H"forIPS>123Rut4Hub5+------------------NameServMoPowerhlpdmer.Bank12Switch;v1User's+.ON5sec---------01StatusGuideFFSite+------------ID:BootIPS15Dlay+LiveDemoUnit

Figure 5.2: The Plug Status Screen - Text Interface

c)Via Network: The IPS-15 includes a default IP address (192.168.168.168), which allows you to contact the unit from any network node on the same subnet. When the IPS is installed in a working network environment, it is recommended that you redefine the IP Address, Subnet Mask, and Gateway Address as described in Section 5.3.3.

i.Telnet to the IPS-15's IP address. For example, if the IP address is "192.168.168.168", then on a UNIX system, the Telnet command would be:

$ telnet 192.168.168.168 [Enter]

ii.Note that if the Telnet connection is refused, this may mean that either the IP Security feature has denied the connection, or the unit is operating on a 100BaseT network that does not autosense for 10BaseT devices (see Section 4.4.)

2.Password: If the System Password has been defined, the unit will display the Password Prompt. Key in either the System Password or User Password, and press [Enter]. If the System Password has not been defined, the prompt will not be displayed when the unit is accessed via the Text Interface. Note that the Password feature is case sensitive.

3.If a valid System Password or User Password is entered, the IPS will display the Plug Status Screen as shown in

5-4Figure 5.2, followed by the IPS> Command Prompt.