Woods Equipment 211716 Mount Installation, Loader Mounting Kit, Tractor Preparation

211716 LOADER MOUNTING KIT

Tractor Preparation

■Only use 211716 Loader Mounting Kit for

mounting Woods 1009, 1012, LC96 and LC102 loaders on John Deere® 3120, 3320, 3520, 3720 & 3203 FWA ROPS tractors. Any other use or modi- fication of this mounting kit may result in serious injury or death.

IMPORTANT

■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the PRE-DELIVERY CHECK LIST, DELIVERY CHECK LIST, and PROD- UCT REGISTRATION before equipment is released to the customer.

■Clean threaded holes in the tractor chassis thoroughly, using a tap of the proper size. Paint, rust or debris in the threads may not permit cap screws to be installed and tightened correctly.

For installing this mounting kit, references to right, left, forward, and rearward directions are determined from the operator’s position in the tractor seat.

Leave all hardware loose until loader mount is com- pletely assembled. When assembly is completed, torque hardware to specifications listed on page 7 of this manual.

1.Shut off engine and set parking brake during installation.

2.Remove the tractor front weights and front weight bracket, if equipped.

3.The tractor must be equipped with single multi- function control lever (joystick) and hydraulic cou- plers, available through John Deere.

4.Larger tires may require steering stop adjustment. Tires must clear loader and loader mounts at full oscillation and full turn. See your tractor opera- tor's manual for instructions on steering stop adjustment.

Remove Hydraulic Coupler Bracket

1.Locate tractor female hydraulic couplers located in front of the right operator platform.

2.Disconnect hydraulic couplers from hydraulic lines. Identify the lines with a color code so that they can be reinstalled in the same location.

3.Remove snap rings on back side of coupler bracket and remove hydraulic couplers from cou- pler bracket.

4.Remove two cap screws from tractor housing and remove coupler bracket shown in Figure 1.

Remove Hardware and Coupler Bracket

DP1

Figure 1. Remove Hydraulic Coupler Bracket

4 Mount Installation

(Rev. 9/29/2011) MAN0426 (3/3/2006)