Woods Equipment 59LB-1 manual Lift Assembly

First put belt on the bottom groove, right hand side of the center sheave. Then thread it to left, around the left hand sheave.

Figure 6.

Bring the belt back across the center sheave in the center groove over to the right outside sheave.

Figure 7.

Then thread it back across the front of the center sheave in the top groove.

Figure 8.

Proper Twist: The belt then follows with a 3/4 twist back under the left V-idler, up over the drive sheave and back down under the right idler pulley. This will leave a 1/4 twist in the section of belt extending from the right V-idler to lower groove of the center mower sheave.

Adjust the mower to proper cutting height. The front of the mower should be slightly lower than the rear of the best cutting and least power requirement.

Idler Adjustment: Make minor belt adjustment with idlers but keep left idler about 1" above being in line with the groove in which the belt runs on the center sheave of the mower and right idler about 1" below. Move mower fore and aft for major adjustments. On L306K210, K260, S, and F10, use belt takeup idlers on mower deck for major adjustment.

Make major adjustments by sliding mower fore and aft, using six holes in channel arms as required. Using a new belt, the push arms normally will be attached to the idler frame with mower sitting in second hole from front end of channels.

Minor adjustments are made up and down with idler pulleys. After belt has been run for 15 to 20 minutes, belts should be re-tightened. Run very tight.

Lift Assembly

If casters are used, they should be installed now, but leave out front bolt in caster arm. Using a 3/8 x 1-1/2 bolt and flat washer, attach one end of chain through

29931 (Rev. 8/10/2007) Assembly 11